As I can do a video to show a way to begin the first package when we start a new piece paper mache, is very similar to birds and reptiles, a little different for fish, and beasts, but there much in common at all.
going to forward something here these brief instructions.
- always begins with two large cones of rolled newspaper. To make each cone place 2 sheets and roll forming an L together.
- The 2 cones are placed together, matching the ends and open so that they are united as to wrap a bouquet of flowers, the tips below give the animal's mouth.
- Grabs packaging for a place to stop along the neck down but the head. The bottom is secured with a flexible thin wire by twisting the wire all around and tightening a bit, this will give some strength to the structure of the neck. In the part reserved for the head not brought wire.
- well After that big cone filled ball tight paper sheets made with any newspaper or crumpled paper.
- Finally we tied the free end with fine wire, the package will be the animal's body, one here decides its volume according to the animal that projects do. Wallpapering
- bulk with thick strips of torn newspaper and glued, you can use each time 3 or 4 strips glued together to advance faster. First is covered from neck to tail and turns to meet again but this time from tail to neck. Not papered or neck or tail. Put
- bulk to dry air and sun. At this point your form will look similar to an egg
- back to paper and drying in both directions until it is hard.
- almost always cut the paper that extends into the tail
Here at this point is continued depending on the animal we're doing, in the case of fish instructions neck to be useless. In the case of other animals will be necessary make the head aside, as examples can see step by step the elephant and caribou.
To attach the legs using large wire rack can be pierced, the package is introduced and bend wire, a wire for every 2 feet, if the queue is too large and needs strength will be placed wire.
0 comments:
Post a Comment